This 2.25 Gallon tank from DevilsOwn is the first water-methanol tank with a built in sump and fluid control baffle. This eliminates the pickup being uncovered during sprinted driving. Because of the tanks quality design and it featuring a real sump in it, you can run the tank down to approximately 1 qt of fluid before uncovering the pickup. This tank is made with 1/4" thick HDPE, which is the same material and construction that is commonly used in manufacturing fuel cells.

Dimensions are 8" x 13.5" x 8.5". So It's best suited for trunk placement.

This tank features a 2 1/4" opening for easy fill up. This tank can be used for any alcohol water mixtures. It's 100% methanol compatible. Tanks design also allows for proper ventilation for the pump heat. Vented cap is included. This tank does not come with drain fitting. We recommend our self sealing bulkhead.

***PLUS***

Self Seal Float Switch can easily be mounted in your alcohol/water tank. You just drill a 7/8"hole and slip it threw. Then just tighten the attached nut to provide a leak free seal. Others on the market need to be dropped in from the fill hole and then use a nut to tighten it to the tank. This is simply the easiest on the market to install.

Design Features?

• Material:Polypropylene,PVDF
• Max.pressure:10bar
• Max.temperature:100
• Liquid density:from 0.6g/ml on

Design Features ?

• High or low level sensing by rotating through 180º
• Internal fitting
• Reed Switch reliability
• Buna-N sealing components
• Easy installation
• Suitable for a wide range of liquids

Can be used with our controller as a warning system, Connect this level switch to the chassis ground with one of it's wires and the other to the pumps ground wire. When the level drops the fault light on the controller will activate when the system sees your start point of boost. Or this can be wired to an led light.